Question Set

1. If for a silicon n-p-n transistor, the base to emitter voltage (VBE) is 0.7 V and the collector to base voltage VCB is 0.2 Volt, then the transistor is operating in the





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 12.51 am
    Transistor will operate in active mode because VBE = 0.7 volt, (Base emitter junction is forward biased) VCB = - VBC = - 0.2 V (Base to collector junction is reverse biased).
Show Similar Question And Answers
QA->A man is facing East, then the turns left and goes 10 m, then turns right and goes 5 m, then goes 5 m to the South and from there 5 m to West. In which direction is he, from his original place ?....
QA->John started from his home and walked 12 km.Then he took a right turn and walked 4 km.Then again,he took a right turn and walked 8 km and finally took another right turn and walked 1 km.How far is he from his home now?....
QA->A cyclist goes 40 km towards East and then turning to right he goes 40 km. Again he turn to his left and goes 20 kn. After this he turns to his left and goes 40 km, then again turns right and goes 10 km. I-low far is he from his starting point ?....
QA->Arjun walks 20 m towards North. Then he turns right and walks 30 ms. Again he turns right and walks 35 ms. Then he turns left and walk 15 ms. How far and in which direction Arjun now from his starting point?....
QA->The device used for converting current from a lower voltage to a higher voltage is known as?....
MCQ->If for a silicon n-p-n transistor, the base to emitter voltage (VBE) is 0.7 V and the collector to base voltage VCB is 0.2 Volt, then the transistor is operating in the....
MCQ->If a transistor is operating with both of its Junctions forward biased, but with the collector base forward biased, but with the collector base forward bias greater than the emitter-base forward bias, then it is operating in the....
MCQ->Which of the following conditions must be satisfied for a transistor to remain under saturation? Its collector to base junction should be under forward bias.Its collector to base junction should be under reverse bias.Its emitter to base junction should be under reverse bias.Its emitter to base junction should be under forward bias. Select the correct answer from the codes given below:....
MCQ->The voltage measured from the collector to the emitter is the sum of the voltage base-emitter plus the voltage collector-base.....
MCQ->The voltage measured from the collector to the emitter is the sum of the base-emitter voltage plus the collector-base voltage.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution