Assertion (A): In an n-p-n transistor as the electrons enter the collector region, they are accelerated towards the collector terminal. Reason (R): Emitter base junction in BJT is forward biased. p> ?->(Show Answer!)

Question Set

1. Assertion (A): In an n-p-n transistor as the electrons enter the collector region, they are accelerated towards the collector terminal. Reason (R): Emitter base junction in BJT is forward biased.

Show Similar Question And Answers

QA->Two trains are 2 km apart and their lengths are 200 m and 300 m. They are approaching towards each other with a speed of 20 m/s and 30 m/s respectivety. after how much time they cross each other....

QA->To be biased against....

QA->A Compass needle just above a wire in which electrons are moving towards east, will point?....

QA->At which place in Jharkhand, Prime Minister Narendra Modi dedicated to nation the second Multi Modal Terminal constructed on the river Ganga and built at a cost of 290 crores under Jal Marg ₹ Vikas Project (JMVP)?....

QA->In which district is Vallarpadam Container Terminal?....

MCQ->Assertion (A): In an n-p-n transistor as the electrons enter the collector region, they are accelerated towards the collector terminal. Reason (R): Emitter base junction in BJT is forward biased.

MCQ->Which of the following conditions must be satisfied for a transistor to remain under saturation? Its collector to base junction should be under forward bias.Its collector to base junction should be under reverse bias.Its emitter to base junction should be under reverse bias.Its emitter to base junction should be under forward bias. Select the correct answer from the codes given below:....

MCQ->Assertion (A): A BJT can be used as a switch. Reason (R): In forward active mode emitter base junction is forward biased and base collector junction is reverse biased.

MCQ->If a transistor is operating with both of its Junctions forward biased, but with the collector base forward biased, but with the collector base forward bias greater than the emitter-base forward bias, then it is operating in the....

MCQ->For the BJT to operate in the saturation region, the base-emitter junction must be ________-biased and the base-collector junction must be ________-biased.....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution