Question Set

1. A generator of 50 Ω internal impedance and operating at 1 GHz feeds a 75 Ω load via a coaxial line of characteristic impedance 50 Ω. The VSWR on the feed line is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 12.55 am
    ZL = 75 Ω Zo = 50 Ω ∴ Reflection coefficient: ∴ .
Show Similar Question And Answers
QA->Via tria, via tuta....
QA->In a fort, there is provision of feed for 150 men for 45 days. After 10 days 25 men left the fort. The remaining feed will last for :....
QA->In the armature and the field magnet of a generator; the stationary part is the:....
QA->The range of electromagnetic spectrum between 10 KHz and 1 GHz is called:....
QA->An animal that feeds its young with milk from the female mammary glands....
MCQ->A generator of 50 Ω internal impedance and operating at 1 GHz feeds a 75 Ω load via a coaxial line of characteristic impedance 50 Ω. The VSWR on the feed line is....
MCQ->Consider the following statements for a driving point function F(jω): Re F(jω) is an even function of ω and is 0 or positive for all values of ω.Im F(jω) is an even function of ω and is 0 or positive for all values of ω.Re F(jω) is an odd function of ω and is 0 or negative for all values of ω.Re F(s) = 0 for Re s = 0. Which one of the statements given above is/are correct?....
MCQ->An AC source or RMS voltage 20V with internal impedance Zs = (1 + 2j) Ω feeds a load of impedance ZL = (7 + 4j) Ω in the figure below. The reactive power consumed by the load is ....
MCQ->Consider the following statements: For a square waveguide of cross-section 3m x 3m it has been found At 6 GHz dominant mode will propagateAt 4 GHz only dominant modes and evanescentAt 11 GHz all the modes and no higher order mode will propagateAt 7 GHz degenerate modes will propagate Which of the above statements are correct?....
MCQ->On moving the feed line (q-line) from saturated liquid feed (vertical position) to saturated vapor feed (horizontal feed), if the slope of both the operating lines are to be increased, then it will result in....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution