1. Two D flip-flop as shown below are to be connected as a synchronous counter that goes through the following Q1Q0 sequence 00 → 01 → 11 → 10 → 00 → __________ The inputs D0 and D1 respectively should be connected as





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 12.56 am
Show Similar Question And Answers
QA->A cyclist goes 40 km towards East and then turning to right he goes 40 km. Again he turn to his left and goes 20 kn. After this he turns to his left and goes 40 km, then again turns right and goes 10 km. I-low far is he from his starting point ?....
QA->A man is facing East, then the turns left and goes 10 m, then turns right and goes 5 m, then goes 5 m to the South and from there 5 m to West. In which direction is he, from his original place ?....
QA->A boat goes 24 km upstream and 28 km downstream in 6 hrs. It goes 30 km upstream and 21 km downstream in 6 hrs and 30 minutes. The speed of the boat in still water is:....
QA->A boat goes 24 km upstream and 28 km downstream in 6 hrs. It goes 30 km upstream and 21 km downstream in 6 hrs and 30 minutes. The speed of the boat in still water is....
QA->Present ages of Kiran and Syam are in the ratio of 5:4 respectively. Three years hence, the ratio of their ages will become 11:9 respectively. What is Syam"s present age in years?....
MCQ->Two D flip-flop as shown below are to be connected as a synchronous counter that goes through the following Q1Q0 sequence 00 → 01 → 11 → 10 → 00 → __________ The inputs D0 and D1 respectively should be connected as ....
MCQ->4 bit ripple counter and 4 bit synchronous counter are made using flip-flop having a propagation delay of 10 ns each. If the worst case delay in the ripple counter and the synchronous counter be R and S respectively, then....
MCQ->Consider the following statements: Race around condition can occur in JK flip flop when both inputs are 1A flip flop is used to store one bit of informationA transparent latch is a D type flip flopMaster slave flip flop is used to store two bits of information Which of the above are correct?....
MCQ->Consider the following statements: A flip-flop is used to store 1-bit of information. Race-around condition occurs in a J-K flip-flop when both the inputs are 1. Master-slave configuration is used in flip-flops to store 2-bits of information A transparent latch consists of a D-type flip-flop. Which of the above statements is/are correct?....
MCQ->Read the following statements The circuitry of ripple counter is more complex than that of synchronous counter.The maximum frequency of operation of ripple counter depends on the modulus of the counter.The maximum frequency of operation of synchronous counter does not depend on the modulus of the counter. Which of the above statements are correct?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution