Question Set

1. In PSK modulation, the input signal is :



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The piece of hardware that converts your computer’s digital signal to an analog signal that can travel over telephone lines is called a–....
QA->കംപ്യൂട്ടർ പ്രൊസസിങ് നടക്കുന്നതിന് മുൻപ് Input Dataയിൽ മാറ്റം വരുത്തുന്നത്.....
QA->Which of the following groups consists of only input devices?....
QA->Most common input device used today is ?....
QA->Which input device can not be used to work in MS - OFFICE ?....
MCQ->In PSK modulation, the input signal is :....
MCQ->In amplitude modulation the rms value of radio frequency voltage after 40% modulation is 60 mV. If modulation is 80% the rms value after modulation will be about....
MCQ->Assertion (A): If a carrier is modulated by three sine waves and m1, m2, m3 are the modulation indices, the total modulation index mt is mt = (m12 + m22 + m32)0.5Reason (R): An AM, higher the level of modulation, lower is the audio power required to produce modulation.

....
MCQ->If an input signal is applied to the inverting input of an op-amp with the noninverting input grounded, the output signal would be opposite in polarity with the input.....
MCQ->If an input signal is applied to the inverting input of an op-amp with the noninverting input grounded, the output signal would be opposite in polarity to the input.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution