Question Set

1. Match the following: List I List II A.Tangent galvanometer1.Can be used for dc onlyB.Moving coil instrument2.Integrating instrumentC.Household energy meter3.Used for voltage measurement onlyD.Electrostatic instrument4.Absolute instrument





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A charge of current in neighbouring coil will induce (contribute) a voltage (emf) in a coil is termed as?....
QA->A man started to walk East. After moving a distance he turned to his right. After moving a distance he turned to his right again. After moving a little he turned in the end of his left. In which direction he going is now?....
QA->Voltage range for household purpose?....
QA->State list, Union list, Concurrent list are included in which of the following schedule....
QA->State list, Union list, Concurrent list are included in which of the following schedule....
MCQ->Match the following: List I List II A.Tangent galvanometer1.Can be used for dc onlyB.Moving coil instrument2.Integrating instrumentC.Household energy meter3.Used for voltage measurement onlyD.Electrostatic instrument4.Absolute instrument

....
MCQ->Match the following: List I (Instrument) List II (Parameters) A.Moving coil galvanometer1.High inertia, soft spring controlB.Ballistic galvanometer2.No control, high dampingC.Vibration galvanometer3.Soft spring control, critical dampingD.Moving coil flux meter4.Low inertia, tuned spring control

....
MCQ->Match the following: List I List II A.Digital counter1.Measurement of harmonicsB.Schering Bridge2.Measurement of frequencyC.Meggar3.Measurement of loss angle of dielectricD.Spectrum analyser4.Measurement of insulation resistance

....
MCQ->Consider the following statements regarding sources or error in a Q-meter: If a coil with resistance R is connected in direct measurement mode and if the residual resistance of Q-meter is 0.1 R, then the measure Q of the coil would be 1.1 times the actual Q.If the inductance to be measured is less than 0.1 mH, the error due to presence of residual inductance cannot be neglected.The presence of distributed capacitance in a coil modifies the effective Q of the coil. Which of the above statements are correct?....
MCQ->Assertion (A): An electrostatic voltmeter is free from hysteresis and eddy current errors.Reason (R): An electrostatic voltmeter has a number of fixed and moving vanes in parallel.

....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution