Question Set

1. Assertion (A): If WF is Fermi energy, v is velocity of electron and m is mass of electron, then .Reason (R): Conductivity of a metal depends on temperature and impurity concentration.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The velocity of photo electron emitted in photoelectric effect depends only on?....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->The process by which water diffuses through a semi-permeable membrane from a region of higher concentration of a solution to a region of lower concentration of a solution?....
QA->The movement of particles or molecules of a substance from the region of higher concentration to a region of lower concentration is called ........?....
QA->Osmosis is the flow of solution from higher concentration to a solution of lower concentration through a semi permeable membrane. What is incorrect in this statement?....
MCQ->Assertion (A): If WF is Fermi energy, v is velocity of electron and m is mass of electron, then .Reason (R): Conductivity of a metal depends on temperature and impurity concentration.

....
MCQ->Consider the following statements: The conductivity of a metal has negative temperature coefficient since: The electron concentration increases with temperature.The electron mobility decreases with temperature.The electron-lattice scattering rate increases with temperature. Which of the above statements is/are correct?....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Assertion (A): For most metals, Fermi energy EF is less than 10 eV.Reason (R): Fermi level of a metal is given by EF = 3.64 x 10-19 (n)2/3 where n is number of free electrons/m3 of metal.

....
MCQ->Assertion (A): Electron concentration n, hole concentration p and charge concentration ni are related by ni2 = np.Reason (R): p type semiconductor is obtained by adding trivalent impurity to intrinsic semiconductor.

....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution