1. Assertion (A): Resistivity of a perfect single crystal of a metal goes to zero as T approaches zero.Reason (R): Scattering of electrons is due to deviations from perfect periodicity of lattice.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A cyclist goes 40 km towards East and then turning to right he goes 40 km. Again he turn to his left and goes 20 kn. After this he turns to his left and goes 40 km, then again turns right and goes 10 km. I-low far is he from his starting point ?....
QA->A man is facing East, then the turns left and goes 10 m, then turns right and goes 5 m, then goes 5 m to the South and from there 5 m to West. In which direction is he, from his original place ?....
QA->A boat goes 24 km upstream and 28 km downstream in 6 hrs. It goes 30 km upstream and 21 km downstream in 6 hrs and 30 minutes. The speed of the boat in still water is:....
QA->A boat goes 24 km upstream and 28 km downstream in 6 hrs. It goes 30 km upstream and 21 km downstream in 6 hrs and 30 minutes. The speed of the boat in still water is....
QA->Scattering of light due to colloidal particle is termed as?....
MCQ->Assertion (A): Resistivity of a perfect single crystal of a metal goes to zero as T approaches zero.Reason (R): Scattering of electrons is due to deviations from perfect periodicity of lattice.

....
MCQ->A cyclist goes 40 km towards East and then turning to right he goes 40 km. Again he turn to his left and goes 20 km. After this he turns to his left and goes 40 km, then again he turns right and goes 10 km. How far is he from his starting point?....
MCQ->For as ω approaches infinity, the magnitude approaches zero and phase angle approaches - 90°.....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->At T = 0, the resistivity of a perfect single crystal of a metal is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution