Question Set

1. Carbon steel has a residual flux density of 1 Wb/m2.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Which steel firm has won the Prime Minister’s trophy for ‘Best Performing Integrated Steel Plant’ in 2015-16?....
QA->The unit of magnetic flux density?....
QA->Radio Carbon (carbon -14) has a half life of?....
QA->Stainless Steel ഉണ്ടാക്കാൻ Steel ൻ്റെകുടെ ചേർക്കുന്ന ലോഹം....
QA->What is Residual hill in the desert region?....
MCQ->Carbon steel has a residual flux density of 1 Wb/m2.....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->From a homogeneous and isotropic dielectric material of dielectric constant ∈r, a small volume element is taken out creating a cavity. The field can be kept homogeneous if Di. (i.e., electric flux density inside the cavity) and D0 (i.e., electric flux density outside the cavity) are such that....
MCQ->Consider the following statements regarding tensile test diagrams for carbon steel with varying carbon contents : As the carbon content increases 1. the ultimate strength of steel decreases 2. the elongation before fracture increases 3. the ductility of the metal decreases 4. the ultimate strength increases. Of these statements :....
MCQ->Consider the following statements regarding sources or error in a Q-meter: If a coil with resistance R is connected in direct measurement mode and if the residual resistance of Q-meter is 0.1 R, then the measure Q of the coil would be 1.1 times the actual Q.If the inductance to be measured is less than 0.1 mH, the error due to presence of residual inductance cannot be neglected.The presence of distributed capacitance in a coil modifies the effective Q of the coil. Which of the above statements are correct?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution