Question Set

1. Resistivity of metals consists of two parts, one part constant and the other temperature dependent.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->.....is a device by virtue of which two persons at two different places can communicate. It consists of two main parts (i) a microphone and (ii) a receiver.?....
QA->Giridharlal’s family consists of his wife Radha. 3 sons and 2 daughters. One daughter is yet to be married and the other daughter has a son. Two sons have 2 children each and the third son has 3 children. An old aunt and sonin-law also stay with them. How many members are there in Giridharlal’s family ?....
QA->Two trains are 2 km apart and their lengths are 200 m and 300 m. They are approaching towards each other with a speed of 20 m/s and 30 m/s respectivety. after how much time they cross each other....
QA->A family consists of two grandparents, two parents and three grandchildren. The average age of the grandparents is 67 years, that of the parents is 35 years and that of the grandchildren is 6 years. The average age of the family is....
QA->“Hindus and Muslims form one nation in India. They are two eyes of India, injure one and you injure the other”-Whose thoughts were these?....
MCQ->Resistivity of metals consists of two parts, one part constant and the other temperature dependent.....
MCQ->The rule that resistivity of conductors can be separated into two parts viz. temperature independent and temperature dependent is known as....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->A copper specimen has resistivity equal to 1.8 x 10-8 ohm-m at room temperature. At a temperature of 700 K, the resistivity is likely to be....
MCQ->A large field of 900 hectares is divided into two parts. The difference of the areas of the two parts is one-fifth of the average of the two areas. What is the area of the smaller part in hectares....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution