1. A CT is used to feed current coils of wattmeter, energy meter, power factor meter and an ammeter. Then





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Union Minister of State for Power and New and Renewable Energy (IC) and Skill Development and Entrepreneurship, RK Singh approved a proposal to declare __________ as Renewable Energy.....
QA->A man is facing East, then the turns left and goes 10 m, then turns right and goes 5 m, then goes 5 m to the South and from there 5 m to West. In which direction is he, from his original place ?....
QA->In a fort, there is provision of feed for 150 men for 45 days. After 10 days 25 men left the fort. The remaining feed will last for :....
QA->A man who can swim 48 m/minute in still water. He swims 200 m against the current and 200 m with the current. If the difference between those two times is 10 minutes, what is the speed of the current?....
QA->A man who can swim 48 m/minute in still water. He swims 200 m against the current and 200 m with the current. If the difference between those two times is 10 minutes, what is the speed of the current?....
MCQ->A CT is used to feed current coils of wattmeter, energy meter, power factor meter and an ammeter. Then....
MCQ->Consider the following statements as regards induction and dynamometer wattmeters Dynamometer wattmeters can be used for dc only.Induction wattmeter has higher torque and dynamometer wattmeter.Induction wattmeter is less accurate, has more power consumption and more weight than dynamometer wattmeter. Which of the above statements are correct?....
MCQ->Assertion (A): In two wattmeter method of 3 phase power measurement, one of the wattmeters would read negative if power factor of load is less than 0.5.Reason (R): In two wattmeter method of 3 phase power measurement, both the wattmeters would show equal readings if power factor of load is unity.

....
MCQ->Assertion (A): A low power factor wattmeter has special constructional features to ensure accurate measurement.Reason (R): Extension of wattmeter range in dc circuit can be easily done by using current and potential transformer.

....
MCQ->A resistance is measured by voltmeter-ammeter method. The voltmeter is 0-250V, ± 1% accuracy and ammeter is 0-5 A, ± 1 % accuracy. The readings of voltmeter and ammeter are 100 V and 2 A respectively. The error in the measured resistance can be....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution