1. High speed logic circuits use





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.04 am
    High speed means time period is small. Therefore pulses should also have small width.
Show Similar Question And Answers
QA->Speed of a speed-boat when moving in the direction perpendicular to the direction of the current is 25 km/h, speed of the current is 5 km/h. So, the speed of the boat against the current will be:....
QA->Speed of a speed-boat when moving in the direction perpendicular to the direction of the current is 25 km/h, speed of the current is 5 km/h. So, the speed of the boat against the current will be:....
QA->India govt plan to construct new corridor for high speed train with speed range 300-350 kmph. What is the present maximum speed of long distance train in India?....
QA->Raju Starts from A to B at a speed of 10 km/hr and returns with a speed of 15 km/hr. What is the average speed of the journey ?....
QA->Speed of a swimmer when moving in the direction perpendicular to the direction of the current is 16 km/h, speed of the current is 3 km/h. So the speed of the swimmer against the current will be (in km/h):....
MCQ->Consider the following statements Gunn diode can be used in combinational logic circuits.Gunn diode can be used in sequential logic circuits.Both Gunn diode and GaAs Mesfet can be used in logic circuits. Which of the above statements are correct?....
MCQ->The RAM circuit given below is suspected of being bad. A check with a logic probe shows pulse activity on all of the address lines and data inputs. The / line and inputs are forced HIGH and the data output lines are checked with the logic probe. Q0, Q2, and Q3 show a dim indication on the logic probe; Q1 indicates a HIGH level on the logic probe. What, if anything, is wrong with the circuit?

....
MCQ->A major drawback in using ECL logic circuits in conjunction with TTL and MOS circuits is its negative supply voltages and logic levels.....
MCQ->The problem of different current requirements when CMOS logic circuits are driving TTL logic circuits can usually be overcome by the addition of:....
MCQ->The terms "low speed" and "high speed," applied to logic circuits, refer to the ________.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution