1. The path length between ports 1 and 2 for the two waves in a hybrid ring is


Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.05 am
    The quantities required to be measured in microwave circuits are frequency, power and impedance. Microwave frequency measurement is done by slotted line, resonant cavities and transfer oscillator. Microwave power measurement uses bolometers and microwave power meters. A self balancing bridge working on the principle of power substitution is commonly used. Microwave impedance measurement is done by measurement of reflection coefficient and VSWR. A slotted line and probe is a basic tool for these measurements.' Network analyser enables rapid impedance measurement over a broad frequency range.
Show Similar Question And Answers
QA->The length of a park is 50m and the breadth is 35m. The width of a path running around the park is 5m. Find the area of the path?....
QA->A girl started counting the fingers of her left hand, calling the thumb 1, the index finger 2, middle finger 3, ring finger 4, little finger 5 and then reversed the direction calling the ring finger 6 middle finger 7 and do on. She counted upto She ended counting on ……………… finger....
QA->Six bells start ringing together and ring at intervals of 4, 8, 10, 12, 15 and 20 seconds respectively. how many times will they ring together in 60 minutes ?....
QA->Five bells ring at the intervals of 2,3,4,5 and 8 respectively. They will ring together after?....
QA->The sum of squares of two numbers is 80 and the square of difference between the two numbers is Find the product of two numbers.....
MCQ->Consider the following statements about hybrid ring Ports 1 and 2 are decoupled.Port 3 and 4 are coupled.A signal entering either port 1 or 2 splits equally between ports 3 and 4.A signal entering either port 3 or 4 splits equally between ports 1 and 2. Which of the above are correct?....
MCQ->The path length between ports 1 and 2 for the two waves in a hybrid ring is....
MCQ->To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met? Each end of the trunk link must be set to the IEEE 802.1e encapsulation. The VTP management domain name of both switches must be set the same. All ports on both the switches must be set as access ports. One of the two switches must be configured as a VTP server. A rollover cable is required to connect the two switches together. A router must be used to forward VTP traffic between VLANs.....
MCQ->If Sample class has a Length property with get and set accessors then which of the following statements will work correctly? Sample.Length = 20; Sample m = new Sample(); m.Length = 10; Console.WriteLine(Sample.Length); Sample m = new Sample(); int len; len = m.Length; Sample m = new Sample(); m.Length = m.Length + 20;....
MCQ->Consider the following statements: 1. India has 13 Major Ports 2. The combined capacity of the major ports is less than the combined capacity of all the minor ports Which among the above statements is/ are correct?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution