Question Set

1. In figure, power in 6 Ω resistor is zero then V =





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.06 am
    Power in 6Ω resistor can be zero only if current in 6Ω resistor is zero. Therefore, voltages of nodes a and b are equal . Since equal resistances of 5Ω are on two sides of node b, .
Show Similar Question And Answers
QA->.If three resistances 6 ohm,4 ohm and 3 ohm are connected in parallel,what will be the total resistance?....
QA->A man is facing East, then the turns left and goes 10 m, then turns right and goes 5 m, then goes 5 m to the South and from there 5 m to West. In which direction is he, from his original place ?....
QA->What minimum number of non-zero non-collinear vectors is required to produce a zero vector?....
QA->The minimum number of non-zero non-collinear vectors required to produce a zero vector is?....
QA->The average of 20 numbers is zero. Of them , at the most ,how many may be greater than zero?....
MCQ->A 3-ohm resistor is connected is parallel to 6-ohm resistor.The combination is connected in series to an 8-ohm resistor.A 10-ohm resistor is connected in parallel to the whole combination.The effective resistance is:....
MCQ->The parallel combination of a 6.8 k resistor and a 10 k resistor is in series with the parallel combination of a 2.2 k resistor and a 1 k resistor. A 100 V source is connected across the circuit. The resistor(s) with the greatest voltage drop is (are)....
MCQ->The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The noise factor is....
MCQ->The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The output signal-to-noise ratio is....
MCQ->The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The input signal-to noise ratio is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution