1. In a circuit using a full wave converter (M - 2 connection) the PIV of each thyristor is 400 V. For the same output voltage and fully controlled bridge converter, PIV will be





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.11 am
    In bridge connection PIV is half of that in M-2 connection.
Show Similar Question And Answers
QA->Which of these methods involves passing paper through a press twice but using one same plate each time to print two complete signatures on each sheet ?....
QA->In an examination A obtains 48 % of full marks and B obtains 33% of full marks. Together they get 567 marks. Find the full marks :....
QA->Which is electrical circuits used to get smooth de output from a rectified circuit called?....
QA->A, B and C start at the same time in the same direction to run around a circular stadium. A completes a round in 252 seconds, B in 308 seconds and c in 198 seconds, all starting at the same point. After what time will they again at the starting point ?....
QA->The electronic circuit which works only on two voltage levels (0 and 1) is called?....
MCQ->In a circuit using a full wave converter (M - 2 connection) the PIV of each thyristor is 400 V. For the same output voltage and fully controlled bridge converter, PIV will be....
MCQ->In a full wave converter (M - 2 connection) feeding an RLE load, the peak thyristor current is 15 A. For fully controlled bridge circuit and same load current, the peak thyristor current will be....
MCQ->Match the following: List I (Circuits) List II (Output dc voltage)A.Single phase half wave converter1.B.Fully controlled bridge converter (1 phase) with RLE load2.C.3 Phase full converter3.D.Single phase full wave converter (M-2) connection4.

....
MCQ->If Vdc1 is the dc output voltage in half wave controlled rectifier circuit feeding resistive load and Vdc2 is the dc output voltage in full wave controlled rectifier circuit (M - 2 connection) feeding resistive load, then....
MCQ->In a single phase full wave converter (M - 2 connection), the rms transformer voltage is 300 V across each half of secondary. The PIV for each thyristor is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution