Question Set

1. Assertion (A): An ideal rectifier should have unity harmonic factorReason (R): An ideal rectifier should have unity displacement factor.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.11 am
    Ideal rectifier should have zero harmonic factor and unity displacement factor.
Show Similar Question And Answers
QA->By which Amendment the words in the preamble of the Constitution- ‘Unity of nation’ were changed to ‘Unity and Integrity of Nation’?....
QA->Thyroid gland is activated by which harmonic for the secretion of thyroxin?....
QA->‘I have been touring different parts of the world. During these travels, I have had the good fortune to come into contact with several saints and maharshis. But I have frankly to admit that I have never come across one who is spiritually greater than Swami Sree Narayana Guru of Kerala” Whose words are these?....
QA->Non ideal gases approach ideal behavior?....
QA->Which factor does not have influence on the Indian climate?....
MCQ->Assertion (A): An ideal rectifier should have unity harmonic factorReason (R): An ideal rectifier should have unity displacement factor.

....
MCQ->Consider the following rectifier circuits : half-wave rectifier without filterfull-wave rectifier without filterfull-wave rectifier with series inductance filterfull-wave rectifier with capacitance filter. The sequence of these rectifier circuits in decreasing order of their ripple factor is....
MCQ->Assertion (A): A half wave controlled rectifier has poorer efficiency and higher ripple factor than a full wave controlled rectifier.Reason (R): The use of a freewheeling diode in half wave controlled rectifier circuit improves the waveform of load current and circuit power factor.

....
MCQ->Assertion (A): In two wattmeter method of 3 phase power measurement, one of the wattmeters would read negative if power factor of load is less than 0.5.Reason (R): In two wattmeter method of 3 phase power measurement, both the wattmeters would show equal readings if power factor of load is unity.

....
MCQ->Calculate the harmonic distortion component for an output signal having a fundamental amplitude of 3 V and a second harmonic amplitude of 0.25 V.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution