A class A chopper has an input voltage of 200 V. Ton = 1.5 ms and Toff = 4.5 ms. The duty cycle, average output voltage and ripple factor respectively are ?->(Show Answer!)

Question Set

1. A class A chopper has an input voltage of 200 V. Ton = 1.5 ms and Toff = 4.5 ms. The duty cycle, average output voltage and ripple factor respectively are

Show Similar Question And Answers

QA->There are two divisions A and B of a class, consisting of 36 and 44 students respectively. If the average weight of divisions A is 40 kg and that of division b is 35 kg. What is the average weight of the whole class?....

QA->Average height of 10 students in a class is 150 cm. A boy of height 160 cm left the class and a boy of height 148 cm is admitted. Then what is the average height of the students in the class now?....

QA->he average weight of 16 boys in a class is 25 kg and that of the remaining 8 boys is 15 kg. Find the average weights of all the boys in the class.....

QA->There are 50 students in a class. In a class test 22 students get 25 marks each, 18 students get 30 marks each. Each of the remaining gets 16 marks. The average mark of the whole class is :....

QA->The average monthly income of A and B is Rs. The average monthly income of B and C is Rs. 6250 and the average monthly income of A and C is Rs. What is the monthly income of A?....

MCQ->A class A chopper has an input voltage of 200 V. Ton = 1.5 ms and Toff = 4.5 ms. The duty cycle, average output voltage and ripple factor respectively are....

MCQ->A separately excited dc motor is run from a dc source through a chopper. At 600 rpm and rated torque, the duty cycle of chopper is 0.8. At 600 rpm and half the rated torque, the duty cycle is likely to be....

MCQ->If a step down chopper is fed by a dc voltage V with Ton and Toff are on and off periods then is....

MCQ->In a step down chopper using pulse width modulation, Ton = 3 x 10-3 and Toff = 1 x 10-3 s. The chopping frequency is....

MCQ->Assertion (A): If the duty cycle of chopper is low the current would not become discontinuousReason (R): If the time constant L/R of the load in chopper is low the current may become discontinuous.

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution