Which type of flux is used for soldering G.I.Sheets? ?->(Show Answer!)

Question Set

1. Which type of flux is used for soldering G.I.Sheets?

Show Similar Question And Answers

QA->.Soldering of two metals is possible because of the property of:....

QA->Flux reacts with the impurities to form fusible material. which is known as which name?....

QA->Galvanised iron sheets have a coating of which metal?....

QA->Scientists of which country have developed a method to convert Jute fibre into low-cost Bio-Degradable cellulose sheets dubbed as 'Sonali'?....

QA->Printing press which uses a continuous roll of paper rather than individual precut sheets ?....

MCQ->Which type of flux is used for soldering G.I.Sheets?....

MCQ->Which of the following statements are correct about datatypes in C#.NET? Every datatype is either a value type or a reference type. Value types are always created on the heap. Reference types are always created on the stack. Mapping of every value type to a type in Common Type System facilitates Interoperability in C#.NET. Every reference type gets mapped to a type in Common Type System.....

MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....

MCQ->For over 500 years, paper was only available and sold as single sheets. In 1902, an inventive Australian used half size sheets of paper, a bit of glue and cardboard to create the what?....

MCQ->Which of the following statements are correct? We can assign values of any type to variables of type object. When a variable of a value type is converted to object, it is said to be unboxed. When a variable of type object is converted to a value type, it is said to be boxed. Boolean variable cannot have a value of null. When a value type is boxed, an entirely new object must be allocated and constructed.....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution