Question Set

1. For centrifugal pump impeller, the maximum value of the vane exit angle is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A liquid will not wet the surface of solid if the angle of contact is which angle?....
QA->The complete reflection of a light ray reaching an interface with a less dense medium when the angle of incidence exceeds the critical angle is called Total Internal?....
QA->The angle of elevation of the top of a hill at the foot of a tower is 60° and the angle of elevation of the top of the tower from the foot of the hill is 30°. If the tower is 50 m high, the height of the hill is—....
QA->The process of adjusting the quantity of fuel delivered by the fuel injection pump is:....
QA->The adjacent angles of a parallelogram is in the ratio 2:The value of smallest angle is…………....
MCQ->For centrifugal pump impeller, the maximum value of the vane exit angle is....
MCQ->The impeller of a centrifugal pump has an internal diameter of 400 mm and it runs at 720 rpm.If the constant radial flow through impeller is 51 m/s,the inlet vane angle will be:....
MCQ->S1: This weather-vane often tops a church spire, tower or high building. P : They are only wind-vanes. Q : Neither alone can tell us what the weather will be. R : They are designed to point to direction from which the wind is coming. S : Just as the barometer only tells us the pressure of air, the weather-vane tells us the direction of wind. S6: The weather-vane can, however give us some indication of other. The Proper sequence should be:....
MCQ->Consider a centrifugal pump having a specific impeller diameter, fixed impeller speed pumping a liquid of constant density at a particular discharge capacity. With decrease in the capacity of the pump, the __________ decreases.....
MCQ->A centrifugal pump is used to pump water through a horizontal distance of 150 m, and then raised to an overhead tank 10 m above. The pipe is smooth with an I.D of 50 mm. What head (m of water) must the pump generate at its exit (E) to deliver water at a flow rate of 0.001 m3/s? The Fanning friction factor, f is 0.0062. ....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution