Question Set

1. In the assembly of pulley, key and shaft





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->കീബോർഡിലെ Escape Key (Esc Key) എവിടെയാണ് കാണാൻ സാധിക്കുക? ....
QA->Which is the Master Key of the Key Board?....
QA->Which type of gear permits lower position of propeller shaft?....
QA->In an automobile gear transmission the counter shaft drive gear is meshed with the gear on the:....
QA->The member of the Constituent Assembly who made the remark that “The Preamble is the most precious part of the Constitution. It is the soul of the Constitution. It is the key to the Constitution”?....
MCQ->Which of the following statements are correct about a .NET Assembly? It is the smallest deployable unit. Each assembly has only one entry point - Main(), WinMain() or DLLMain(). An assembly can be a Shared assembly or a Private assembly. An assembly can contain only code and data. An assembly is always in the form of an EXE file.....
MCQ->The 2-kg shaft CA passes through a smooth journal bearing at B. Initially, the springs, which are coiled loosely around the shaft, are unstretched when no force is applied to the shaft. In this position s = sª = 250 and the shaft is originally at rest. If a horizontal force of F = 5 kN is applied, determine the speed of the shaft at the instant s = 50 mm, sª = 450 mm. The ends of the springs are attached to the bearing at B and the caps at C and A.....
MCQ->If diameter of driver and driven pulley are 10 cm and 20 cm respectively and if,the driver pulley rotates at a speed of 200 rpm,find the speed of driven pulley:....
MCQ->When the material of key and shaft is same, and the width of key is one-fourth of the diameter of shaft (d), then length of key will be....
MCQ->Two shafts 'A' and 'B' are made of same material. The shaft 'A' is solid and has diameter D. The shaft 'B' is hollow with outer diameter D and inner diameter D/2. The strength of hollow shaft in torsion is __________ as that of solid shaft.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution