The lead screw of a lathe has __________ threads. ?->(Show Answer!)

Question Set

1. The lead screw of a lathe has __________ threads.

Ask Your Doubts Here

Comments

Show Similar Question And Answers

QA->Tie rod ends have the following threads:....

QA->In a bid to fill the vacant seats in trains and meet the challenges posed by the roadways and airways, the Indian Railways has decided to give discount of up to __________ to passengers on ticket fares in air-conditioned executive class and chair cars of trains like Shatabdi Express, Gatiman Express, Tejas Express, Double Decker and Intercity Express.....

QA->The discharged lead acid battery has on its plates”....

QA->Union Minister of State for Power and New and Renewable Energy (IC) and Skill Development and Entrepreneurship, RK Singh approved a proposal to declare __________ as Renewable Energy.....

QA->Factory __________ was increased 20%.....

MCQ->It is required to cut screw threads of 2 mm pitch on a lathe. The lead screw has a pitch of 6 mm. If the spindle speed is 60 r.p.m., then the speed of lead screw will be....

MCQ->The lead screw of a lathe has __________ threads.....

MCQ->When screw threads are to be used in a situation where power is being transmitted in one direction only, then the screw threads suitable for this will be....

MCQ->Statements: All needles are threads. All threads are boxes. All trees are boxes. Conclusions: No needle is tree. Some trees are threads. Some boxes are needles. Some trees are needles.

....

MCQ->The square threads are not so strong as V-threads but they offer less frictional resistance to motion than Whitworth threads.....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution