Question Set

1. In orthogonal cutting system, the maximum chip thickness occurs at the middle.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A girl started counting the fingers of her left hand, calling the thumb 1, the index finger 2, middle finger 3, ring finger 4, little finger 5 and then reversed the direction calling the ring finger 6 middle finger 7 and do on. She counted upto She ended counting on ……………… finger....
QA->Which rays can pass through 20 cm thickness of steel?....
QA->IC Chip was invented by?....
QA->IC chip using Silicon was invented by?....
QA->The thickness of certain ceramics changes when a voltage is applied across them this property is called?....
MCQ->In an orthogonal cutting, the depth of cut is halved and the feed rate is double. If the chip thickness ratio is unaffected with the changed cutting conditions, the actual chip thickness will be....
MCQ->In orthogonal cutting system, the maximum chip thickness occurs at the middle.....
MCQ->In oblique cutting system, the maximum chip thickness occurs at the middle.....
MCQ->In oblique cutting system, the maximum chip thickness....
MCQ->In continuous chip cutting, the maximum heat is taken by the cutting tool.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution