Question Set

1. Carbon tool steels have low-heat and wear-resistance.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->‘I have been touring different parts of the world. During these travels, I have had the good fortune to come into contact with several saints and maharshis. But I have frankly to admit that I have never come across one who is spiritually greater than Swami Sree Narayana Guru of Kerala” Whose words are these?....
QA->Transistor transfers a signal from a low resistance to?....
QA->“During my travels throughout the world, I have had the good fortune to come in contact with several saints and maharishis... But I have frankly to admit that I have never come across one who is spiritually greater than Swami Narayana Guru or a person who is at par with him in spiritual attainment.” Who paid tribute in the above words after visiting Sree Narayana Guru?....
QA->A cyclist goes 40 km towards East and then turning to right he goes 40 km. Again he turn to his left and goes 20 kn. After this he turns to his left and goes 40 km, then again turns right and goes 10 km. I-low far is he from his starting point ?....
QA->Radio Carbon (carbon -14) has a half life of?....
MCQ->Carbon tool steels have low-heat and wear-resistance.....
MCQ->Wearing locations of rails and their reasons are listed below : 1. Wear at end of rails : Loose fish bolts 2. Wear at sides of rail head : Constant lerake application 3. Wear on the top of rail head on tangent truck : Rigidity of wheel base 4. Wear on top of rail head on curves : Lesser area of contact between wheel and rail Which of the pairs given above are correctly matched ?....
MCQ->Carbon percentage in high speed steel tool material is 0.6 to 1.0. The hardness of carbon tool steels is increased, when it is alloyed with....
MCQ->Steels with high carbon equivalent have poor weldability, because in these steels during welding....
MCQ->Low carbon steels are those in which carbon percentage is around....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution