Question Set

1. In metal cutting, use of low feeds and high cutting speeds is desired when the objective is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->.....is an instrument for determining speeds of aeroplanes and motor boats.?....
QA->The minimum desired area which is considered safe for a tropical country like India?....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->A cyclist goes 40 km towards East and then turning to right he goes 40 km. Again he turn to his left and goes 20 kn. After this he turns to his left and goes 40 km, then again turns right and goes 10 km. I-low far is he from his starting point ?....
QA->Large astronomical telescopes always use as objective?....
MCQ->In metal cutting, use of low feeds and high cutting speeds is desired when the objective is....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->An 8 bit transistor register has output voltage of low-high-low-high-low-high-low-high. The decimal number stored is....
MCQ->If A is LOW or B is LOW or BOTH are LOW, then X is LOW. If A is HIGH and B is HIGH, then X is HIGH. These rules specify the operation of a(n) ________.....
MCQ->Read the following statements as regards register pairs in microprocessor 8085B represents B, C pair with B as high order register and C as low order register.D represents D, E pair with D as high order register and E as low order register.H represents H, L pair with H as high order register and L as low order register. Which of the above statements are correct?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution