Question Set

1. A process of removing metal by pushing or pulling a cutting tool is called





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The process of removing anther from a bisexual flower?....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->When the first metal tool came into being why was it used for?....
QA->Substances used for removing excess of chlorine from textiles after their bleaching are in general called?....
QA->The substances which are capable of removing water vapour from other substances are called?....
MCQ->A process of removing metal by pushing or pulling a cutting tool is called....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->The following operations are generally employed for tunnelling in hard rock. 1. Removing ground water, 2. Loading holes and firing the explosive 3. Setting up and drilling 4. Grouting and lining 5. Removing muck 6. Ventilation and removing explosion dust The correct sequence is :....
MCQ->The angle which is found between the face of the cutting tool and the normal to the machined surface at the cutting edge is called:....
MCQ->The angle between the face of the tool and a line tangent to the machined surface at the cutting point is called cutting angle.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution