Question Set

1. The depth of cut in drilling is __________ the drill diameter.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The drill ship deputed to study the secrets of lost Continent Zealand is :....
QA->Which was India’s first mobile offshore drilling platform?....
QA->Which allotrope of the carbon is used in cutting and drilling?....
QA->Moho discontinuity lies at the depth of approximately how many kilometers?....
QA->Which is the greatest known ocean depth (which lies in the Pacific Ocean)?....
MCQ->A drill bit of 20 mm diameter rotating at 500 r.p.m. with a feed rate of 0.2 mm/revolution is used to drill a through-hole in a mild steel plate 20 mm thickness. The depth of cut in this drilling operation is....
MCQ->The depth of cut in drilling is __________ the drill diameter.....
MCQ->Tap drill depth does not include the cone point of the drill.....
MCQ->A tailor had a number of shirt pieces to cut from a roll of fabric. He cut each roll of equal length into 10 pieces. He cut at the rate of 45 cuts a minute. How many rolls would be cut in 24 minutes ?....
MCQ->If the helix angle of the drill is made __________ 30°, then the torque required to drive the drill at a given feed will be more.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution