Question Set

1. In down milling, the thickness of chip is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Which rays can pass through 20 cm thickness of steel?....
QA->IC Chip was invented by?....
QA->IC chip using Silicon was invented by?....
QA->The thickness of certain ceramics changes when a voltage is applied across them this property is called?....
QA->‘IC’ chip for computers are usually made of?....
MCQ->In down milling, the thickness of chip is....
MCQ->In an orthogonal cutting, the depth of cut is halved and the feed rate is double. If the chip thickness ratio is unaffected with the changed cutting conditions, the actual chip thickness will be....
MCQ->In up milling, the thickness of chip is....
MCQ->The following quantities refer to a channel section used as a beam : b = width of flange (upto centre of web thickness). h = depth of web (c/c of flange thickness). t = thickness of flange and web. I = moment of inertia of channel about xx axis. e = distance of shear centre, outside the channel from the mid thickness of the web. The value of 'e' is given by....
MCQ->Small-scale integration, abbreviated _____ refers to fewer than 12 gates on the same chip. Medium-scale integration (MSI) means 12 to 100 gates per chip. And large-scale integration (LSI) refers to more than _____ gates per chip.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution