Question Set

1. The chisel edge angle of a drill is usually 120° to 135°.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A liquid will not wet the surface of solid if the angle of contact is which angle?....
QA->The complete reflection of a light ray reaching an interface with a less dense medium when the angle of incidence exceeds the critical angle is called Total Internal?....
QA->The angle of elevation of the top of a hill at the foot of a tower is 60° and the angle of elevation of the top of the tower from the foot of the hill is 30°. If the tower is 50 m high, the height of the hill is—....
QA->The drill ship deputed to study the secrets of lost Continent Zealand is :....
QA->Chemical mastication is operational after (deg. Centigrade)....
MCQ->The chisel edge angle of a drill is usually 120° to 135°.....
MCQ->The obtuse angle, included between the chisel edge and the lip as viewed from the end of a drill, is called....
MCQ->If the helix angle of the drill is made __________ 30°, then the torque required to drive the drill at a given feed will be more.....
MCQ->The cutting speed of a drill varies from point to point on the cutting edge of the drill.....
MCQ->1000 Kg of liquid at 30°C in a well stirred vessel has to be heated to 120°C, using immersed coils carrying condensing steam at 150°C. The area of the steam coils is 1.2 m2 and the overall heat transfer co-efficient to the liquid is 1500 W/m2.°C. Assuming negligible heat loss to the surrounding and specific heat capacity of the liquid to be 4 kJ/kg.°C, the time taken for the liquid to reach desired temperature will be....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution