Cutting fluids are used to ?->(Show Answer!)

Question Set

1. Cutting fluids are used to

Ask Your Doubts Here

Comments

Show Similar Question And Answers

QA->‘Hydraulic brakes’ and ‘Hydraulic lift’ are devices; why are fluids used in them?....

QA->‘Hydraulic brakes’ and ‘Hydraulic lift’ are devices, why are fluids used in them?....

QA->Which allotrope of the carbon is used in cutting and drilling?....

QA->What material is used for cutting glass?....

QA->Fluids flow with zero viscosity is called?....

MCQ->Tube wall thickness depends on the cor-rosiveness of the fluids and their operating pressure & temperature and is specified by Birmingham wire gauge (B.W.G)-a number which varies from 8 to 18 with the numbers 14 and 16 being more commonly used. Outside diameter of tubes varies from about 15 to 50 mm; however a tube of less than __________ mm outside diameter is generally not recommended for fouling fluids.....

MCQ->A designer chooses the values of fluid flow rates and specific heats in such a manner that the heat capacities of the two fluids are equal. A hot fluid enters the counter flow heat exchanger at 100° C and leaves at 60° C. A cold fluid enters the heat exchanger at 40° C. The mean temperature difference between the two fluids is....

MCQ->Cutting fluids are used to....

MCQ->If d1 is the depth of cutting, d2 is the height of the bank from bed level r2 : 1 and r1 : 1 are the slopes in filling and cutting respectively, the horizontal distance n between the bed and bank, is....

MCQ->The angle which is found between the face of the cutting tool and the normal to the machined surface at the cutting edge is called:....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution