Question Set

1. In oblique cutting system, the tool may or may not generate a surface parallel to the workface.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The fuel used to generate steam in Kayamkulam thermal power plant is?....
QA->Which of the following is not a toning tool?....
QA->ഇന്ത്യയുടെ ഭൂതല-ഭൂതല ( surface to surface) മിസൈൽ?....
QA->When yellow light is incident on a surface no electrons are emitted while green light can emit. If the red light is incident on the surface then?....
QA->“Ask not, Say not, think not caste” are the words of?....
MCQ->In oblique cutting system, the tool may or may not generate a surface parallel to the workface.....
MCQ->In oblique cutting system, the cutting edge of the tool....
MCQ->In oblique cutting of metals, the cutting edge of the tool is....
MCQ->The following statements relate to the pressure exerted by a fluid on a Submerged curved surface : 1. The vertical component of hydrostatic force acting on a submerged curved surface acts through the centre of volume of the fluid directly above the submerged area. 2. The horizontal component of the force acting on a curved surface is the hydrostatic force acting on the vertical projection of the curved surface. 3. The resultant force on a curved surface acts on the bottom of th6 curved surface. Of these statements :....
MCQ->The angle which is found between the face of the cutting tool and the normal to the machined surface at the cutting edge is called:....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution