Question Set

1. In machining metal, cutting force at the cutting edge is measured by a





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->Battle of Water Loo (1815) British force led by Duke of Wellington defeated French force led by ?....
QA->To restrain by force or impel a person by force.....
QA->According to the Periodic Labour Force Survey (PLFS) 2017-18, what percentage of India’s young people (15-29 years) in the labour force are unemployed?....
QA->When a body is immersed partly or wholly in a liquid, a force acts on the body by the liquid in the upward direction. This force is called?....
MCQ->In machining metal, cutting force at the cutting edge is measured by a....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->When the cutting edge of the tool is dull, then during machining....
MCQ->When using edge-triggered flip-flops, the data is entered into the flip-flop on the leading edge of the clock, but the output does not change until the trailing edge of the clock.....
MCQ->Pick out thể one word for - a secret arrangement....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution