Question Set

1. The rate of removing metal is __________ by increasing the depth of cut.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Decrease of viscosity with increasing shear rate is known as....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->The Direct Tax Code (DTC) task force has recommended a major cut in corporate tax for both domestic and foreign companies. What is the newly recommended corporate tax rate for both domestic and foreign companies?....
QA->are based on the principle that the rate of water absorption is essentially equal to the rate of water loss?....
QA->The Employees’ Provident Fund Organisation (EPFO) raised the interest rate on Employees’ Provident Fund (EPF) for 2018-19. What is the new interests rate?....
MCQ->The rate of removing metal is __________ by increasing the depth of cut.....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->The following operations are generally employed for tunnelling in hard rock. 1. Removing ground water, 2. Loading holes and firing the explosive 3. Setting up and drilling 4. Grouting and lining 5. Removing muck 6. Ventilation and removing explosion dust The correct sequence is :....
MCQ->A tailor had a number of shirt pieces to cut from a roll of fabric. He cut each roll of equal length into 10 pieces. He cut at the rate of 45 cuts a minute. How many rolls would be cut in 24 minutes ?....
MCQ->Consider the following specific stages of demographic transition associated with economic development: 1. Low birth rate with low death rate 2. High birth rate with high death rate 3. High birth rate with low death rate Select the correct answer using the codes given below:....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution