Question Set

1. In metal machining, the zone where the maximum heat is generated due to the plastic deformation of metal, is called





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Transfer of heat from hotter region carrying heat to a colder region is called?....
QA->Which acid is usually stored in plastic containers due its high reactivity toward glass?....
QA->The metal or plastic case that: holds all the physical parts of the computer is the–....
QA->With which can Radio wave of constant amplitude be generated?....
QA->By which Radio waves of constant amplitude can be generated?....
MCQ->In metal machining, the zone where the maximum heat is generated due to the plastic deformation of metal, is called....
MCQ->The respective ratio of advertisement revenues generated from printed version by magazine P to advertisement revenues generated from online version by the same magazine in July is same as the respective ratio of advertisement revenues generated from printed version by Magazine Q to advertisement revenues generated from online version by the same magazine in March. If the advertisement revenue generated from online version by Magazine P in July was INR 1,08,000/-, what was the advertisement revenue generated from printed version by the same magazine in July ?....
MCQ->In metal machining, the work-tool contact zone is a zone where heat is generated due to....
MCQ->Whenever some external system of forces acts on a body, it undergoes some deformation. As the body undergoes some deformation, it sets up some resistance to the deformation. This resistance per unit area to deformation, is called....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution