Question Set

1. In machining metals, surface roughness is due to





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The scientist who classified elements into Metals and Non-metals is?....
QA->Elements showing properties of both metals and non-metals are?....
QA->Who Classified Elements as Metals and non-metals?....
QA->The study of metals and the overall process by which metals are extracted from its ores are called?....
QA->The elements which show the properties of both metals and non metals are called?....
MCQ->In machining metals, surface roughness is due to....
MCQ->Which of the following equations as suggested by Colebrook and White gives the increase in roughness of a new surface (ε0) with age/time (t) (where, ε = roughness of the surface after time't'. α = a co-efficient to be experimentally determined)?....
MCQ->In case of hydraulically smooth pipe, the resistance to flow depends only on the Reynolds number, whereas for a hydraulically rough pipe, the resistance to flow is governed by the relative roughness. Two pipes are said to have the same hydraulic roughness, when they have equal values of....
MCQ->The following statements relate to the pressure exerted by a fluid on a Submerged curved surface : 1. The vertical component of hydrostatic force acting on a submerged curved surface acts through the centre of volume of the fluid directly above the submerged area. 2. The horizontal component of the force acting on a curved surface is the hydrostatic force acting on the vertical projection of the curved surface. 3. The resultant force on a curved surface acts on the bottom of th6 curved surface. Of these statements :....
MCQ->The ferrous metals require more machining allowance than non-ferrous metals.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution