Question Set

1. Flank wear is due to the abrasive action of hard mis-constituents including debris from built up edge as the work material rubs the work surface.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Insects which feed on waste material such as dead bodies; debris etc are called?....
QA->What are the metallic constituents of hard water?....
QA->____ gives the author of an original work exclusive right for a certain time period in relation to that work, including its publication, distribution and adaptation:....
QA->In the hard ticks the dorsum of its body is covered by a hard shield is called....
QA->P and Q can do a work in 30 days. Q and R can do the same work in 24 days and R and P in 20 days. They started the work together, but Q and R left after 10 days. How many days more will P take to finish the work?....
MCQ->Flank wear is due to the abrasive action of hard mis-constituents including debris from built up edge as the work material rubs the work surface.....
MCQ->Wearing locations of rails and their reasons are listed below : 1. Wear at end of rails : Loose fish bolts 2. Wear at sides of rail head : Constant lerake application 3. Wear on the top of rail head on tangent truck : Rigidity of wheel base 4. Wear on top of rail head on curves : Lesser area of contact between wheel and rail Which of the pairs given above are correctly matched ?....
MCQ->The following statements relate to the pressure exerted by a fluid on a Submerged curved surface : 1. The vertical component of hydrostatic force acting on a submerged curved surface acts through the centre of volume of the fluid directly above the submerged area. 2. The horizontal component of the force acting on a curved surface is the hydrostatic force acting on the vertical projection of the curved surface. 3. The resultant force on a curved surface acts on the bottom of th6 curved surface. Of these statements :....
MCQ->The displacement of a flat-faced follower when it has contact with the flank of a circular arc cam, is given by (where R = Radius of flank, r1 = Minimum radius of the cam, and θ = Angle turned through by the cam)....
MCQ->A rectangular surface 3' x 4', has the lower 3 edge horizontal and 6' below a free oil surface (sp. gr. 0.8). The surface inclination is 300 with the horizontal. The force on one side of the surface is(where, y = specific weight of water)....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution