The amount of water evaporated from feed water at __________ into dry and saturated steam at 100° C at normal atmospheric pressure is called equivalent evaporation from and at 100° C. ?->(Show Answer!)

Question Set

1. The amount of water evaporated from feed water at __________ into dry and saturated steam at 100° C at normal atmospheric pressure is called equivalent evaporation from and at 100° C.

Show Similar Question And Answers

QA->Water evaporates at atmospheric pressure at a certain rate. If now the some water is placed in vaccum. The rate of evaporation?....

QA->When liquid boils and changes itself into vapour at standard atmospheric pressure is called?....

QA->A small weight is put on the pressure cooker. It increases the pressure of the steam. Why?....

QA->In a fort, there is provision of feed for 150 men for 45 days. After 10 days 25 men left the fort. The remaining feed will last for :....

QA->A liquid boils at a temperature at which its saturated vapour pressure becomes?....

MCQ->The amount of water evaporated from feed water at __________ into dry and saturated steam at 100° C at normal atmospheric pressure is called equivalent evaporation from and at 100° C.....

MCQ->The amount of water evaporated from and at 100° C into dry and saturated steam is called evaporative capacity of a boiler.....

MCQ->Steam economy is defined as the amount of evaporation per unit amount of steam used, while the capacity is the total evaporation obtained per hour. Use of multiple effect in evaporation....

MCQ->On moving the feed line (q-line) from saturated liquid feed (vertical position) to saturated vapor feed (horizontal feed), if the slope of both the operating lines are to be increased, then it will result in....

MCQ->In a laboratory test run, the rate of drying was found to be 0.5 x 10-3 kg/m2.s, when the moisture content reduced from 0.4 to 0.1 on dry basis. The critical moisture content of the material is 0.08 on a dry basis. A tray dryer is used to dry 100 kg (dry basis) of the same material under identical conditions. The surface area of the material is 0.04 m2/kg of dry solid. The time required (in seconds) to reduce the moisture content of the solids from 0.3 to 0.2 (dry basis) is....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution