Toggle navigation
Home
KPSC Previous Question Papers
Article Category
kerala psc
upsc
General
Popular Pages
Multiple Choice Question in aptitude-area
Multiple Choice Question in non-verbal-reasoning-grouping-of-images
Multiple Choice Question in aptitude-compound-interest
Multiple Choice Question in engineering-mechanics-kinetics-of-a-particle-impulse-and-momentum
Multiple Choice Question in electronic-devices-bipolar-junction-transistors
Multiple Choice Question in 035/2016
Multiple Choice Question in database-database-redesign
Question Answer in malayalam-kerala-psc-questions
Multiple Choice Question in malayalam-kerala-psc-questions
Multiple Choice Question in current-affairs-2017-03-05
Question Answer in KERALA PSC
Multiple Choice Question in KERALA PSC
Question Answer Bank
Multiple Choice Question Bank
Question Answer Category
Multiple Choice Question Category
Home
->
Multiple Choice Questions
Question Set
mechanical engineering steam nozzles and turbines
1. The steam enters the nozzle at a
(A): high pressure and a high velocity
(B): high pressure and a low velocity
(C): low pressure and a high velocity
(D): low pressure and a low velocity
Previous Question
Show Answer
Next Question
Add Tags
Report Error
Show Marks
Ask Your Doubts Here
Type in
(Press Ctrl+g to toggle between English and the chosen language)
Post reply
Comments
Show Similar Question And Answers
QA->The Tibetan river ‘Tsangpo’ enters India through which State?....
QA->Which is a round worm that enters man’s body through the soles of the feet?....
QA->Total internal reflection of light is possible when light enters from which thing?....
QA->Which is the process in which no heat enters or leaves?....
QA->When Light enters from air to water then its?....
MCQ->The velocity of steam leaving the nozzle (V) is given by (where K = Nozzle coefficient or nozzle efficiency, and hd = Enthalpy or heat drop during expansion of steam in a nozzle)....
MCQ->A nozzle is fitted at the end of a pipe whose length is 320 m and diameter is 10 cm. If the value of f = 0.01, the diameter of the nozzle for the maximum transmission of power through the nozzle is....
MCQ->When the back pressure of a nozzle is below the designed value of pressure at exit of nozzle, the nozzle is said to be....
MCQ->A nozzle is said to be a convergent-divergent nozzle, when the cross-section of a nozzle first decreases from its entrance to throat and then increases from its throat to exit.....
MCQ->The steam enters the nozzle at a....
×
×
Type The Issue
×
Your Marks
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...
Privacy
|
Terms And Conditions
Question ANSWER With Solution