Question Set

1. When the gas is heated at constant volume, the heat supplied





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->At constant pressure the volume of a definite mass of a gas is directly proportional to the?....
QA->For a body moving with constant speed in a horizontal circle; what remains constant?....
QA->For a body moving with constant speed in a horizontal circle, what remains constant?....
QA->When water is heated from degree C to 20 degree C; how does its volume change?....
QA->What happens; When water is heated from °C to 10°C the volume of water?....
MCQ->The heat supplied to the gaS at constant volume is (where m = Mass of gas, cv = Specific heat at constant volume, cp = Specific heat at constant pressure, T2 - T1 = Rise in temperature, and R = Gas constant)....
MCQ->When the gas is heated at constant volume, the heat supplied increases the internal energy of the gas.....
MCQ->In an air-standard Otto-cycle,the compression ratio is The condition at the beginning of the compression process is 100 kPa and 300K.Heat added at constant volume is 1500 kJ/kg,while 700 kJ/kg of heat is rejected during the other constant volume process in the cycle.Specific gas constant for air=287 kJ/kgK.The mean effective pressure(in kPa)of the cycle is:....
MCQ->When the gas is heated at constant volume, the heat supplied....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution