Question Set

1. The low pressure acetylene is produced at the welding site by the chemical reaction between water and calcium carbonate.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Which winds are flowing from sub tropical high pressure to sub polar low pressure?....
QA->A substance that speeds up a chemical reaction without being consumed itself in the reaction....
QA->Sodium carbonate crystals lose water molecules. What is this property called?....
QA->A cyclist goes 40 km towards East and then turning to right he goes 40 km. Again he turn to his left and goes 20 kn. After this he turns to his left and goes 40 km, then again turns right and goes 10 km. I-low far is he from his starting point ?....
QA->Water evaporates at atmospheric pressure at a certain rate. If now the some water is placed in vaccum. The rate of evaporation?....
MCQ->The low pressure acetylene is produced at the welding site by the chemical reaction between water and calcium carbonate.....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->1 kg of calcium carbide (CaC2) produces about 0.41 kg of acetylene gas on treatment with water. How many hours of service can be derived from 1 kg of calcium carbide in an acetylene lamp burning 35 litres of gas at NTP per hour ?....
MCQ->Rate constant for a first order reaction does not depend upon reaction time, extent of reaction and the initial concentration of reactants ; but it is a function of reaction temperature. In a chemical reaction, the time required to reduce the concentration of reactant from 100 gm moles/litre to 50 gm moles/litre is same as that required to reduce it from 2 gm moles/litre to 1 gm mole/litre in the same volume. Then the order of this reaction is....
MCQ->If neutral flame is used in oxy-acetylene welding, both oxygen and acetylene cylinders of the same capacity will be emptied at the same time.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution