When the weld is made from left to right, it is known as back-hand welding. ?->(Show Answer!)

Question Set

1. When the weld is made from left to right, it is known as back-hand welding.

Show Similar Question And Answers

QA->A cyclist goes 40 km towards East and then turning to right he goes 40 km. Again he turn to his left and goes 20 kn. After this he turns to his left and goes 40 km, then again turns right and goes 10 km. I-low far is he from his starting point ?....

QA->Rahim travelled straight from point E to F at a distance of 5 km. From F he turned left and travelled 6 km and reached point G, there he took a left turn and travelled 5 km to reach point H. He took another left turn and travelled 2 km and reached point I. How far is he from the starting point ?....

QA->Arun started walking towards North after walking 30m, he turned left and walked 40m. He then turned left and walked 30m. He again turned left and walked 50m. How far is he from his original position....

QA->In a row of 16 boys, when Ram moves two places towards left, he becomes 7th from the left end. What was his earlier position from right end of the row ?....

QA->. In a row of boys Manu who is 8th from the left and Siju who is 9th from the right interchange their seats. Now Manu becomes 15th from left. How many boys are there in the row ?....

MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....

MCQ->What will be the output of the program? public class If1 { static boolean b; public static void main(String [] args) { short hand = 42; if ( hand < 50 && !b ) / Line 7 / hand++; if ( hand > 50 ); / Line 9 / else if ( hand > 40 ) { hand += 7; hand++; } else --hand; System.out.println(hand); } }....

MCQ->When the weld is made from left to right, it is known as back-hand welding.....

MCQ->In fore-hand welding, the angle between the welding torch and the work is __________ as compared to back-hand welding.....

MCQ->In back-hand welding, the angle between the welding rod and the work is __________ as compared to fore-hand welding.....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution