Question Set

1. In welding magnesium with TIG arc welding, direct current with __________ is used.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The device used to convert alternating current (AC) to Direct Current (DC)?....
QA->Which device converts alternating current (AC) to direct current (DC)?....
QA->A.C ( Alternative Current) യെ D.C ( Direct Current) ആക്കി മാറ്റുന്ന ഇലക്ട്രോണിക്സ് സംവിധാനത്തിന് പറയുന്ന പേര്....
QA->A.C ( Alternative Current) യെ D.C ( Direct Current) ആക്കി മാറ്റുന്ന ഇലക്ട്രോണിക്സ് സംവിധാനത്തിന് പറയുന്ന പേര് ?....
QA->Speed of a swimmer when moving in the direction perpendicular to the direction of the current is 16 km/h, speed of the current is 3 km/h. So the speed of the swimmer against the current will be (in km/h):....
MCQ->In welding magnesium with TIG arc welding, direct current with __________ is used.....
MCQ->In welding aluminium with TIG arc welding, alternating current is used.....
MCQ->In welding copper alloys with TIG arc welding....
MCQ->In TIG arc welding, the welding zone is shielded by an atmosphere of....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution