Question Set

1. The welding set up is said to have straight polarity, when





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->‘I have been touring different parts of the world. During these travels, I have had the good fortune to come into contact with several saints and maharshis. But I have frankly to admit that I have never come across one who is spiritually greater than Swami Sree Narayana Guru of Kerala” Whose words are these?....
QA->“During my travels throughout the world, I have had the good fortune to come in contact with several saints and maharishis... But I have frankly to admit that I have never come across one who is spiritually greater than Swami Narayana Guru or a person who is at par with him in spiritual attainment.” Who paid tribute in the above words after visiting Sree Narayana Guru?....
QA->Who said "Well done is better than well said”?....
QA->Who is the inventor of Welding (Electric)?....
QA->Which is used in welding industry?....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->The welding set up is said to have straight polarity, when....
MCQ->The welding set up is said to have reversed polarity when the work is connected to the negative terminal and the electrode holder to the positive terminal.....
MCQ->A network administrator is connecting hosts A and B directly through their Ethernet interfaces, as shown in the illustration. Ping attempts between the hosts are unsuccessful. What can be done to provide connectivity between the hosts? A crossover cable should be used in place of the straight-through cable. A rollover cable should be used in place of the straight-through cable. The subnet masks should be set to 255.255.255.192. A default gateway needs to be set on each host. The subnet masks should be set to 255.255.255.0.....
MCQ->Match the following: List I (Set operation) List II (Set operator)A.Set equality1.-B.Set inclusion2.=C.Set intersection3.< =D.Set difference4.∗

....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution