Question Set

1. Metal patterns require __________ draft allowance than wooden patterns.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->R is taller than X, but shorter than Z, Q is taller than Z, Y is taller than X, but shorter than R, Who is the shortest?....
QA->In Kiran’s opinion, his weight is greater than 65 kg but less than 72 kg. His brother does not agree with Kiran and he thinks that Kiran’s weight is greater than 60 kg but less than 70 kg. His mother’s view is that his weight cannot be greater than 68 kg. If all are them are correct in their estimation, what is the average of different probable weights of Kiran?....
QA->In an examination of mathematics Rajesh obtained more marks than the total marks obtained by Rahim and Sabu. The total marks obtained by Rahim and Saji was more than the Rajesh’s. Rajesh obtained more marks than Saji, Reenu obtained more marks than Rajesh. Who amongst them obtained the....
QA->Rekha is taller than Asha. Deepa is as tall as Priti. Supriya is shorter than Veena. Sita is taller than Asha. Veena is shorter than Deepa. Who is the shortest ?....
QA->Rekha is taller than Asha. Deepa is as tall as Priti. Supriya is shorter than Veena. Sita is taller than Asha. Veena is shorter than Deepa. Who is the shortest ?....
MCQ->Metal patterns require __________ draft allowance than wooden patterns.....
MCQ->The metal patterns as compared to wooden patterns require less....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->If an aluminium pattern made from a wooden master pattern is to be used for grey iron castings, then the shrinkage allowance allowed on the wooden pattern should be....
MCQ->Draft allowance given to patterns is for....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution