Question Set

1. In a __________ , the molten metal is poured and allowed to solidify while the mould is revolving.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The oldest rocks in the earth's crust were once molten; and came from deep inside the earth. The molten rock; called magma; spewed out in volcanic eruptions during the earth;s early life and solidified into hard rock's called?....
QA->In a bid to fill the vacant seats in trains and meet the challenges posed by the roadways and airways, the Indian Railways has decided to give discount of up to __________ to passengers on ticket fares in air-conditioned executive class and chair cars of trains like Shatabdi Express, Gatiman Express, Tejas Express, Double Decker and Intercity Express.....
QA->Union Minister of State for Power and New and Renewable Energy (IC) and Skill Development and Entrepreneurship, RK Singh approved a proposal to declare __________ as Renewable Energy.....
QA->__________ helps to give uniform margin on all sheets while typing.....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
MCQ->In a __________ , the molten metal is poured and allowed to solidify while the mould is revolving.....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->In a die casting method, the molten metal is forced into mould under high pressure.....
MCQ->A pattern is used to make the mould cavity for pouring the molten metal for casting.....
MCQ->When the molten metal is fed in the cavity of a metallic mould by gravity, the method of casting is known as....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution