Question Set

1. Seam welding is best adopted for metal thickness ranging from





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->The electromagnetic radiation with wavelength ranging from 10nm to 380nm?....
QA->Short waves ranging from 14mto 60m are used for?....
QA->Frequency ranging from 300 MHZ to 3 GHz is called?....
QA->Which rays can pass through 20 cm thickness of steel?....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Seam welding is best adopted for metal thickness ranging from....
MCQ->Projection welding & stud welding is categorised as the __________ welding.....
MCQ->In fore-hand welding, the angle between the welding torch and the work is __________ as compared to back-hand welding.....
MCQ->In back-hand welding, the angle between the welding rod and the work is __________ as compared to fore-hand welding.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution