Question Set

1. The operation of cutting a sheet of metal in a straight line along the length, is known as





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->If a graph is plotted taking the temperature in Fahrenheit along the Y-axis and the corresponding temperature in Celsius along X- axis it will be the straight line?....
QA->The incapability of a body to change by itself its state of rest or its state of uniform motion along a straight line?....
QA->In which mode of transmission, the heat waves travel along the straight line with the speed of light?....
QA->Light travels in a straight line. This property is known as?....
QA->A metal sheet with circular hole is heated. what change will be in the hole?....
MCQ->The operation of cutting a sheet of metal in a straight line along the length, is known as....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->How many people are standing between K and L in a straight line of 15 people (Note: All are standing in a straight line facing north) I. S stands eleventh from the right end of the line. L stands exactly at the centre of the line. There are as many people to the right of K as there are to the left of S. II. R stands fourth from the left end of the line. S is an immediate neighbour of R. Only two people stand between L and S. Only two people stand between K and S.....
MCQ->Consider the following statements relating to hydraulic gradient line and energy gradient line 1. In the case of a fluid flowing in a pipeline, hydraulic gradient line and energy gradient line may coincide. 2. The line joining the points representing piezometric heads is known as hydraulic gradient line. 3. In the case of ideal fluid, energy gradient line is always horizontal. 4. Hydraulic gradient line has a downward slope in the case of flow through pipes. Of these statements :....
MCQ->If Sample class has a Length property with get and set accessors then which of the following statements will work correctly? Sample.Length = 20; Sample m = new Sample(); m.Length = 10; Console.WriteLine(Sample.Length); Sample m = new Sample(); int len; len = m.Length; Sample m = new Sample(); m.Length = m.Length + 20;....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution