Question Set

1. When two pieces of different metals are to be welded by projection welding, then the projection should be made on the metal piece having __________ conductivity.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->.....is a device by virtue of which two persons at two different places can communicate. It consists of two main parts (i) a microphone and (ii) a receiver.?....
QA->The gases used in different types of welding would include?....
QA->Which pair of metals constitutes the lightest metal and the heaviest metal; respectively?....
QA->Which pair of metals constitutes the lightest metal and the heaviest metal, respectively?....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->When two pieces of different metals are to be welded by projection welding, then the projection should be made on the metal piece having __________ conductivity.....
MCQ->When two metal pieces of different thicknesses are to be welded by projection welding, then the projections should be made on __________ metal piece.....
MCQ->Aruna cut a cake into two halves and cuts one half into smaller pieces of equal size. Each of the small pieces is twenty grams in weight. If she has seven pieces of the cake in all with her, how heavy was the original cake ?....
MCQ->Projection welding & stud welding is categorised as the __________ welding.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution