Question Set

1. Fin is a casting defect which is due to thin projections of metal not intended as a part of casting.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Name the defect where text and images are visible through the page because the paper is not sufficiently opaque ?....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->What is caused due to the permanent damage caused to any part of brain tissues due to inadequate supply of blood?....
QA->Which scheme was intended to tap the black money?....
QA->It is useful for removing an unwanted portion of or a defect in your image in Photoshop:....
MCQ->Fin is a casting defect which is due to thin projections of metal not intended as a part of casting.....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Extended heat transfer surface like fins are used to increase the heat transfer rate. Fin efficiency is defined as the ratio of heat transferred across the fin surface to the theoretical heat transfer across an equal area held at the....
MCQ->Scab is a casting defect which occurs as sand patches on the upper surface of a casting.....
MCQ->A casting defect which occurs near the ingates as rough lumps on the surface of a casting is known as....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution