Question Set

1. The percentage of residue left after seiving good portland cement in 90 micron sieve should not exceed





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Arun started walking towards North after walking 30m, he turned left and walked 40m. He then turned left and walked 30m. He again turned left and walked 50m. How far is he from his original position....
QA->How much the time gap between two sessions of the Parliament should not exceed?....
QA->Rahim travelled straight from point E to F at a distance of 5 km. From F he turned left and travelled 6 km and reached point G, there he took a left turn and travelled 5 km to reach point H. He took another left turn and travelled 2 km and reached point I. How far is he from the starting point ?....
QA->A man started to walk East. After moving a distance he turned to his right. After moving a distance he turned to his right again. After moving a little he turned in the end of his left. In which direction he going is now?....
QA->A cyclist goes 40 km towards East and then turning to right he goes 40 km. Again he turn to his left and goes 20 kn. After this he turns to his left and goes 40 km, then again turns right and goes 10 km. I-low far is he from his starting point ?....
MCQ->The percentage of residue left after seiving good portland cement in 90 micron sieve should not exceed....
MCQ->Consider the following statements : 1. Tests on cement paste to determine initial and final setting times are done at normal consistency condition. 2. Low heat cement has a high percentage to tricalcium aluminate. 3. High early strength portland cement contains a larger percentage of tricalcium silicate and a lower percentage of dicalcium silicate. Which of these statements are correct ?....
MCQ->Which of the statements regarding to Portland Cement are correct? 1.Silica imparts strength to cement 2.Alumina makes cement quick setting 3.Excess of lime increases strength of cement 4.Calcium sulphate decreases initial setting time of cement Select the correct answer using the code below....
MCQ->If 20 kg of coarse aggregate is sieved through 80 mm, 40 mm, 20 mm, 10 mm, 4.75 mm, 2.36 mm, 1.18 mm, 600 micron, 300 micron and 150 micron standard sieves and the weights retained are 0 kg, 2 kg, 8 kg, 6 kg, 4 kg respectively, the fineness modulus of the aggregate, is....
MCQ->Alumina, silica, lime and iron oxide are the basic raw material for the manufacture of portland cement. The component of Portland cement which first hardens is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution