The length of a ranging rod is: ?->(Show Answer!)

Question Set

1. The length of a ranging rod is:

Show Similar Question And Answers

QA->A train moving with uniform speed passed a bridge of length 2000 metres in 2 ½ minutes.It took ½ minutes to pass a telephone post.What is the length of the train in metres?....

QA->The length and breadth of a rectangular field in the ratio of 12: 7 . Find the length if area of the field is 52,500 Sq.m?....

QA->A train of length 150 meters took 8 seconds to cross a bridge of length 250 meters. Time taken by the train to cross a telephone post is....

QA->The ratio of length and breadth of a rectangle is 7: if perimeter is 52 then, what is the length of the rectangle?....

QA->A train having a length of 240 metre passes a post in 24 seconds. How long will it take to pass a platform having a length of 650 metre?....

MCQ->A 600 mm long and 50 mm diameter rod of steel (E = 200 GPa, α = 12 x 10-6/°C) is attached at the ends to unyielding supports. When the temperature is 30°C there is no stress in the rod. After the temperature of the rod drops to - 20°C, the axial stress in the rod will be....

MCQ->If Sample class has a Length property with get and set accessors then which of the following statements will work correctly? Sample.Length = 20; Sample m = new Sample(); m.Length = 10; Console.WriteLine(Sample.Length); Sample m = new Sample(); int len; len = m.Length; Sample m = new Sample(); m.Length = m.Length + 20;....

MCQ->A steel rod 1 metre long having square cross section is pulled under a tensile load of 8 tonnes. The extension in the rod was 1 mm only. If Esteel = 2 x 106 kg/cm2, the side of the rod, is....

MCQ->A steel rod, 100 mm long is held between two rigid supports. It is heated by 20°C. If the coefficient of thermal expansion of the material of the rod is 15 x 10-6 /° C and modulus of elasticity is 200 x 103 MN/m2, what is the stress in the rod ?....

MCQ->A rod shown in the given figure is such that the lower part is made of steel and the upper part is made of copper. Both the ends of the rod are rigidly clamped. If an axial force P is applied at the junction of the two metals, given that the ratio Esteel/ECopper is equal to 2, then the force in the copper rod would be ....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution